Q--The aluminum storm door at our front entrance sags to the point where it won`t close properly. Is there anything I can do about this short of purchasing a new door?A--In most cases, a metal storm door that sags can be restored to square condition. Start by checking both the door and its metal frame with a carpenter`s square or try square to make sure it is the door and not the frame that is out of shape.If the door is out of square, prop it partly open and look for pairs of screws at the edge of each corner and sometimes in the middle of the door`s side rails. Loosen each of the screws slightly. Have someone hold the door in a square position, using the try square to check, and tighten all of the edge screws. Again check the door to see if it holds the square shape and closes properly.If the door`s metal frame is out of square, loosen the screws holding the frame in the door opening, shift the frame until it is square; If a storm door still sags after you have tightened all the screws, it can usually be pulled into shape with a special door brace sold at some hardware stores and home centers.

The brace is a long rod with a turnbuckle in the middle.The brace is installed diagonally at the bottom of the door, generally on the outside. The ends of the brace are screwed in place and the turnbuckle turned until the door is pulled into a square shape.Many storm doors also have pneumatic closers that sometimes need adjustment to ensure the door is closed completely and quickly. Turning an adjustment screw in the end of the pneumatic tube will increase or decrease the closing speed.back door store cordovaStorm doors should also be checked occasionally to make sure a good seal is achieved when the door is closed. garage door bottom seal round endCracks or gaps between the storm door and its frame can often be closed with weatherstripping. upvc bi folding doors review

The bottom rails of many storm doors can also be adjusted up or down to improve the seal.Broken or loose door latches are a common problem with metal storm doors. Loose latches can usually be tightened by adjusting the strike plate on the door frame. Replacement latches are also available at many hardware stores and home centers.Q--I have a cottage with some unfinished wood paneling that has darkened over the years to a very dark shade. I`d like to lighten the wood and have tried bleaching, but that proved to be an impossible task. bifold closet door remodelI don`t want to paint the wood. front doors upvc colouredA--You might try a technique called pickling to lighten the paneling. amazon outdoor doormatsI suggest experimenting in an inconspicuous area, such as a spot normally concealed by furniture, to see if you like the effect.outdoor patio furniture west chester pa

Here are the basic steps for pickling, which is closer to staining than painting even though paint is used:Brush on a coat of white paint, either latex or alkyd-based, that is thinned by about one-third of its volume. After several minutes, wipe off the paint with lint-free rags. The wiping will remove most of the paint, but leave a very thin film on the surface and a thicker film in the grain and pores. Experimenting with various drying times will give different effects.After the paint is wiped, let it dry completely and sand with fine sandpaper in a finishing sander. This will further thin the surface film and enhance the grain pattern.Finally, give the paneling a coat of satin varnish to protect the pickled finish. Therapists see no developmental benefits from seats`Jop' would be a 4-ever pick for the BullsDark meaning of bubble-gum Pumped Up Kicks is tough to chew Barkley Fined, Suspended For Spitting IncidentToo cold for car wash? Motormouth answers your questionsDouble Murder: A Family Affair?

What kinds of skylights does Andersen Windows make? Andersen Windows does not manufacture skylights as of 2015, as both Andersen skylights and roof windows were discontinued in 2009. Both Andersen skylights and roof windows were Terratone in color, featured an aluminum window sash and were available in numerous sizes. What kinds of products does Andersen Windows and Doors sell? Where can you get an Andersen Windows parts replacement catalog? What sizes of windows does Andersen offer? Although they look similar, there are a number of notable differences between Andersen skylights and stationary roof windows. The company's skylights featured a wood frame, which was not visible from the interior of the home. The glass in the skylights was set against an aluminum frame that featured a stepped design. The glass was also sealed with a fillet bead, which is a silicone seal placed on the exterior of the skylight where the glass meets the aluminum sash. Andersen stationary roof windows also feature a wooden frame that is visible from the inside of the home.

Instead of a fillet bead, the roof windows use a black rubber gasket set against the edge of the glass to seal the window. This rubber gasket is mostly visible from the exterior. Andersen skylights began producing roof windows in 1983 and started making skylights in 1991. In addition to the Andersen brand, the company produces windows and doors under the brands Silver Line and American Craftsman, the latter of which is sold exclusively at The Home Depot. The company also produces a line of replacement windows sold under the name Renewal by Andersen. Does The Home Depot sell Andersen windows? As of May 2015, The Home Depot sells Andersen windows and doors on its website and in its retail locations. The Home Depot also offers window replacement a... How do you change windows and screens on Andersen storm doors? To switch out windows or screens on Andersen storm doors, press to unsnap the retaining strip from the door frame around the entire door, remove the window...